Our LED have the correct volts and will not pop a fuse, the only time a fuse might pop is if you have your car lights on, the most commonly popped fuse is the glove box, we recommend you double check your glove box light is off when installing the LED.
LED not working:
If you followed all of these instructions and your LED still is not working, please contact us.
A few LED troubleshooting tips:
-Try to installing the LED in another car
-Use alligator clamps hooked up to a 9volt battery to test if the LED is working
-Check the fuse box in your car to make sure no fuses are popped
-Turn the LED 180 degrees
-A way to reset the VW/Audi/BMW CANBUS is to place the OEM bulb back into the housing, turn on your car for 5 minutes to make sure your light works, shut off your car and remove your key and then replace with our LED.
Reviews by our Customers:
Please note that these are all honest reviews by our customers, we highly appreciate these real reviews by real customers.
The forum member's name have been listed below in quotes with the link to the review.
If you have any reviews or feedback please send them to us so we can post them here: Support@deAutoLED.com
MK6 GTi LED Interior DIY:
“GS631” DIY MK6 Interior LED Install
MK6 GTi LED Reviews:
”Marble” Ziza vs deAutoLED.com Interior LED Comparison Thread
"spiker369” Review of our MK6 License Plate LED
“spiker369” Pics of our Interior LED sets before and after